![]() Used either for SOFTSERIAL, SONAR or RSSI_ADC*. The 8 pin RC_Input connector has the following pinouts when used in RX_PPM/RX_SERIAL mode Pin Tricopter & Airplane support is untested, please report success or failure if you try it. The board cannot currently be used for hexacopters/octocopters. ![]() Have an on-board USB to uart adapter which connect to the processor's serial port instead. The board has a USB port directly connected to the processor. If issues are found with this board please report via the github issue tracker. It has 6 ports labeled as inputs (one pin each)Īnd 6 ports labeled as motor/servo outputs (3 pins each). It also features a 16Mbit SPI based EEPROM chip. It only has one sensor, the MPU6000 SPI based Accelerometer/Gyro. The OpenPilot Copter Control 3D aka CC3D is a board more tuned to Acrobatic flying or GPS basedĪuto-piloting. OpenPilot Bootloader compatible image mode.
0 Comments
Leave a Reply. |